The configuration factor, introduced by Feilzer and colleagues, is the ratio of bonded to unbonded (free) surfaces in a restoration. A Class I preparation has five bonded walls, the pulpal floor and the four surrounding walls, and only one free occlusal surface, so its C-factor is 5, among the highest of the common cavity designs. A high C-factor means that shrinking composite cannot flow from free surfaces to relieve stress, so stress builds at the bonded interfaces and can cause gap formation, marginal leakage, cuspal deflection and post-operative sensitivity. Option B, about 2, is the usual figure for Class II and Class III preparations. Options A and D, 1 and 0.5, describe situations in which free surfaces equal or outnumber bonded ones, such as incisal-edge Class IV builds or bonding to a flat surface, not a Class I box. Stress is reduced by placing composite in oblique increments of 2 mm or less, using a flowable liner, soft-start or ramped curing, and low-shrinkage or bulk-fill materials designed for the purpose. Exam tip: the larger the C-factor the greater the shrinkage stress, so Class I and box-shaped Class V restorations are the ones that most need incremental placement.