When a conventional low-copper alloy is mixed with mercury, the silver-tin gamma phase dissolves at its surface and two new phases precipitate around the unreacted cores: gamma-1, a silver-mercury matrix, and gamma-2, a tin-mercury phase. Gamma-2 is the weakest and most corrosion-prone component of the set amalgam; it creeps under load, corrodes at the margins, and its corrosion liberates mercury that reacts further, so low-copper restorations show marginal ditching over time. In high-copper alloys, which contain roughly 12 to 30 percent copper either as admixed silver-copper eutectic particles or in a single-composition powder, copper has a greater affinity for tin than mercury does, so the tin is bound up as the copper-tin eta phase and little or no gamma-2 forms. The result is lower creep, higher early and final strength and far better marginal integrity. Option A, gamma, survives as unreacted cores and is strong. Option B, gamma-1, is the matrix that holds the restoration together in both types. Option D, eta, is created by the copper, not eliminated. Exam tip: gamma-2 is the villain, high copper removes it, and the eta phase is the product of that reaction.